The Charlotte Service Center features on-site and in-shop service for motor, switchgear, mechanical and transformer repairs. With access to the global network of ABB Service Centers, Charlotte is truly your total repair solution.

Image

Charlotte Service Center Brochure

Offerings

• Factory authorized warranty repair center
• Emergency 24-hour service
• Experienced engineering and technical support
• EHS and quality personnel
• Fully equipped assembly, repair and inspection shop
• Outage and shutdown planning
• Comprehensive solutions – testing, repair and overhauls
• 50 ton crane capacity
• Engine lathes - up to 130"x420” and 40 ton capacity
• Vertical boring mills – up to 144" table x 120” 
• Balance capabilities up to 60,000 lbs
• 500 ton horizontal press
• Dry Ice cleaning
• Thermography (Infrared)

12037 Goodrich Dr.
Charlotte, NC
28273 
 
P: (704) 587-1300
F: (704) 587-1359

Contact an expert
 

Motor Services

• All manufacturers – all sizes
• DC and AC motors
• On-site and in-shop capabilities
• Electrical and mechanical testing
• Basic overhaul – clean and inspect
• Complete rewinds and insulation system upgrades
• Analysis - Failure, vibration, and infrared
• Laser alignment
• VPI (Vacuum pressure impregnation)
• Digital diagnostic management solutions
• Replacement parts
• Load testing
• Star punched rotor rewinds
• Equipment management programs
• Motor health monitoring

Switchgear Services

• All manufacturers
• On-site and in-shop capabilities
• All voltage classes
• Doble power factor testing
• Loaner circuit breakers
• Phase loss protection installations
• Low Voltage MicroVersa Trip Plus*
• Solid state conversions
• Limitamp* motor starter maintenance and vacuum conversions
• Power management system retrofits
• Diagnostic testing and evaluation
• Total substation maintenance
• Trip curve certification
• Ground fault testing and certification

Mechanical Services

• On-site machine capabilities
• Refiners for paper mills
• Compressors
• Centrifuges – centrifugal and vertical
• Pumps - Vertical, centrifugal, and boiler feed
• Crushers and excavators
• Blowers
• Screw presses, feeders, and fans
• Gears and gear boxes
• Babbitt bearings
• Low-speed balancing
• Optical alignment
• Welding and machining
• Nondestructive testing
• Process machine rebuilding
• Component remanufacturing and upgrading

Transformer Services

• All manufacturers
• On-site testing maintenance
• Dielectric fluid testing
• Monitoring Design installation
• Replacement parts
• Total substation maintenance
• Trip curve certification
• Ground fault testing and certification