Publication Library

Application note - Low voltage control and protection products in high altitudes

Application Note Functional safety and reliability 06 2021

This application note has been written as a general guide for people working with the development and
construction of household appliances.

In this application note will be explained how to connect and configure a Profinet slave to the 800xA system. A PNQ22.0 with 4 connected UMC motor controller will be used as Profinet slave.

After the installation and the first steps it’s necessary to create a new project in Control Builder M. In this application note is described how to open and save a new project and to configure all connected extension modules to the 800M controller. The second part of this manual is how to update the firmware of the connected extension modules. In the last chapter will be explained how to use the integrated webserver and how to find the connected slaves.

25 page guide; Overload heaters for Full Voltage Magnetic and Manual Starters, Reduced Voltage Starters

Discover ABB Load Management solutions to safely start Grow Lightings in Greenhouse Horticulture

Notice of automatic replacement of GE branded mini contactors

Mapping tables for acyclic access to the UMC100.3 - How to access data acyclically
Following communication protocols included: Modubus TCP, Profibus, Profinet, EtherNet/IPTM

NEMA Size 7-9 Contactors and Starters LCM Announcement December 2020

PDF - Motor starting and protection for NEMA Premium Efficiency

Motor starting and protection - IE3/IE4 ready for premium efficiency motor starting and the new AC-3e utilization category

In this Application Note will be described how to set up and create a redundant ring with two Profinet devices PNQ22.0 and four connected UMC100.3 to each device. In addition to that it will be described how to get the diagnostic for each slave.
In the attachment to this application note is a complete example project included. This has to be opened and the CPU and Profinet master have to be adapted to the real used hardware. For an existing project the application can be imported into the project. For this use the attached “REDUNDANT_PROFINET_RING_WITH_AC500.EXP” file.

For some applications only a visualization and the possibility for controlling and monitoring a few devices is needed. In these cases a PLC would be oversized and to expensive.
Instead of the PLC the ABB Eco Panel CP610 can be used. This HMI has an integrated Modbus master and can be used for controlling and monitoring some UMCs which are connected to the Modbus via the communication module MTQ22.0
In this application note an example will be shown, how to create the pages and the tags for writing and reading data. With this example the basic functions of a UMC100.3 can be controlled.
The configuration of the panel can be done completely by using this application note. The complete project is attached to this application note.

After updating to Windows 10, it may happen that no UMC100.3 is visible after installing FIM and the UMC device package. This is due to a communication error between the USB terminal and the UMC panel. The root cause is incorrect driver installation. To correct it, the following process must be carried out.

Easily find the best product to fit in your Power Conversion System based on concrete examples, to switch and protect
your BESS installation from faults, overcurrent events, and other hazards.

Discover our Switching & Protection solutions with the ABB PCS100 ESS in BESS Commercial & Industrial installations

Thermal overload relays - high temperatures and group mounting

The software „Asset Vision Basic” is the frame application for the DTMs of our universal motor controllers.
This software can be used for parametrizing the UMCs and download it directly to the device.
In this document is described how to set up the software and some basic steps for using it.